Browse
 
Tools
Rss Categories

Installation and Configuration

1 Before You Begin Asterisk/LumenVox Installation Featured

Important: Please read this document carefully, especially if you have limited experience with Linux. Installation requires the use of the command line interface, and if you mistype any command your installation will be not be complete. Also note that Linux…

2 Configuring Asterisk 13

Asterisk 13 + UniMRCP 1.3.0 + LumenVox 13.1 We have many customers running Asterisk PBX using our speech services, and these work very well together, however we often hear of users running into difficultly installing and configuring Asterisk or UniMRCP before…

3 Configuring UniMRCP Modules using MRCPv2

Asterisk can interopt with LumenVox via MRCPv1 (RTSP) or MRCPv2 (SIP). Below are the steps to configure Asterisk to to integrate with LumenVox via MRCPv2. In this example, we have Asterisk and LumenVox installed on the same server with IP address = 172.18.2.50.…

4 Installation Video Training Series - Asterisk 13

Seven part video series explaining the installation process of setting up Asterisk to work with Lumenvox. Overview and Installing PJSIP Installing Asterisk 13 Installing the UniMRCP Dependencies Installing the UniMRCP library Installing the asterisk-unimrcp…

5 Installing and Configuring UniMRCP Modules

The preferred method of communicating with the Asterisk PBX is via the use of Asterisk modules provided by the UniMRCP Project. UniMRCP is an open-source implementation of the Media Resource Control Protocol (MRCP) which is fully supported by the LumenVox…

6 Testing the LumenVox Installation on Asterisk

Before testing that the Asterisk-LumenVox functionality is in place, you should verify the basic LumenVox functionality. Once you have verified that the ASR, TTS Server, and/or Media Server are running correctly, you can ensure the LumenVox-Asterisk connectionis…